Solution
Common Trouble and Solution of Laser Cutting Machine
Zhengye Technology provides laser cutting machine equipment to provide you with professional equipment knowledge. Common failures and solutions of laser cutting machine such as UV Laser Cutting Machine are as follows:
1. Bad cutting or no cutting?
The power setting is small, the potentiometer is small, the optical deviation is small, the lens is dirty, the focusing lens is installed in reverse, the focal length, the laser power source, the laser tube power attenuation, the water temperature is too high, the voltage is unsteady, etc. When cutting around the yellow light is not correct, blow small.2 can't connect the device?
Whether the board drive is installed, whether the USB cable or network cable is plugged in, whether the USB cable or network cable is broken, the transfer board is broken, the board card, etc
3. Starting back to the origin and moving in the opposite direction?
Origin break
4 cutting graphics deformation and cutting overlap?
Synchronous wheel screw loose, motor line break, motor failure, driver, voltage, etc
5. If the equipment cannot be started and the power-on room is opened, will it trip?
Whether the emergency stop is picked up, whether the external circuit is connected, whether the equipment is opened or closed, whether the machine is turned on and the sound of a snap is heard. If yes, please check the main contactor and control transformer, etc.; Water protection leakage leads to short circuit of laser power supply, short circuit of pump, too small of indoor open.
In addition to providing laser cutting equipment, we also provide UV Laser Drilling Machine. Welcome to our website know more products details.
