Details of The Laser Cutting Machine

What should you pay attention to when operating a laser cutting machine?

Laser cutting machine is at work, it is very dangerous if the machine fails.  Must be trained by professionals to operate independently before the new operate independently.

What should pay attention to? Give you 13 tips based on the experience of the laser cutting machine safety work.

1, Follow the general operating procedures for laser cutting machines. In strict accordance with the laser launcher to start the laser.

2, Operators must be trained, familiar with the equipment structure, performance, master the operating system knowledge.

3, Wear protective protective equipment as required, wear protective glasses in the vicinity of the laser beam.

4, Do not process this matherials, if can not distinguish whether a material can be used to laser irradiation or heating. So as to avoid the potential hazards of smoke and steam.

5, When the equipment is running, the operator shall not leave the post. If it is necessary to leave, stop the power switch.

6, Place the fire extinguisher in a handy place. Turn off the laser or shutter when not working. Do not place paper, cloth, or other flammable material near unprotected laser beams.

7, In the processing process found abnormal, should immediately stop, timely troubleshooting or  report to the supervisor.

8, Keep the laser, bed and surrounding venues clean, orderly, no oil, workpieces, plates, scrap according to the provisions of the stack.

9, Using cylinders, should avoid crushing the welding wire, so as to avoid leakage accident occurred. Prohibit the cylinder in the sun or near the heat source. When the bottle valve is opened, the operator must stand on the side of the mouth of the cylinder.

10, Comply with high pressure safety regulations during maintenance.

11, Should be manually low speed X, Y direction to start the laser cutting machine. And check to see if there is an abnormality.

12, After inputting new workpiece program, shall be run first, and check the running status.

13, Pay attention to observe the operation of laser cutting machine when working. So that the cutting machine out of the effective range of travel or two collision caused by the accident.